Search

[Q&A] Pin assignments

hine Post time 2016-10-12 09:55:11 |
Hi, I am a Mu user in Japan.
Please let me know the pin assignments on this borad.
I want to know how i connect servos to this board or how I connect Arduino to this board with UART.
Reply

Use magic Report

xiaomu Post time 2016-10-14 05:12:01 |
Please see the attached images for details. Let us know if any questions.

MU PCB

MU PCB

MU PCB I/O

MU PCB I/O

Reply Support Not support

Use magic Report

xiaomu Post time 2016-10-16 00:26:26 |
Makers can build a vision controlled cradle head in the Vision Sensor mode. The wiring diagram is shown in the picture. Servo-X is the meaning of horizontal direction servo which is connected to the IO1 and Servo-Y means the vertical direction. “SIG“ is abbreviated for signal port, "VCC" is power supply port and "GND" is ground port. The "VCC" output voltage is the same as the PCB Input voltage, either via the Battery port or the USB port.

PCB Morpx Wiring Diagram

PCB Morpx Wiring Diagram


The vision sensor commands setting steps can be found here:
    http://www.morpx.com/manuals/visions.pdf

Let us know if any problems. Thank you!
Reply Support Not support

Use magic Report

lucylucky Post time 2016-11-16 11:54:49 |
good!!
Reply

Use magic Report

You have to log in before you can reply Login | Register

Points Rules

hine

Threads

Posts

93

Credits
FORUM NAVIGATION
Copyright © 2017 Morpx All rights reserved 浙ICP备14027877号
Quick Reply To Top Return to the list